Use of edge-sealed hot melt adhesive
1: Temperature at the edge of the semi-automatic edge banding machine
Because the performance of edge-sealing hot-melt adhesives is affected by temperature, temperature is an indicator that needs attention during the edge-sealing process. The temperature of the hot-melt adhesive, the temperature of the substrate, the temperature of the edge-sealing material, and the temperature of the working environment (the workshop where the semi-automatic edge-sealing machine is located) are all very important edge-sealing parameters. On the semi-automatic edge banding machine, because the glue is coated on the substrate, the substrate with too low temperature will cause the hot melt adhesive to cure in advance, which will cause the glue to stick to the substrate, but it will not stick to the edge banding material and the temperature of the substrate. It is best to keep it above 20 ° C. The working temperature of the semi-automatic edge banding machine will affect the curing speed of the glue. Plants often have edge-sealing problems in low-temperature seasons. The reason is that the curing speed of hot-melt adhesives is accelerated at low temperatures and the effective time for bonding is shortened. If the feeding speed of the semi-automatic edge banding machine cannot be changed (in most cases), to ensure the quality of edge banding, the sheet and edge banding materials must be preheated.
2.Semi-automatic edge banding machine processing
The glue line between the edge-sealed board and the edge-sealing band will adversely affect the appearance of the panel furniture. If the amount of glue applied is too large, the glue line will be obvious. Otherwise, the strength of the edge seal will be reduced. For the discontinuous or uneven rubber line phenomenon, there are many reasons. The following factors must be comprehensively considered: the accuracy of the opening of the plate, the edge of the plate must maintain a 90 ° angle with its plane; the edge banding machine Whether the pressure of the pressure roller is evenly distributed and the size is correct, and the pressure direction should be 90 ° with the edge of the board; whether the glue roller is intact, whether the hot melt adhesive is even on it, and whether the amount of glue is appropriate; In a cleaner and less dusty place, during the finishing process, avoid contacting dirty things with the glue line. Shanghai semi-automatic edge banding machine wins trust with enthusiasm, automatic edge banding machine, Shanghai automatic edge banding machine quality station advantage.
Semi automatic edge banding machine
This machine is suitable for the linear edge banding of medium density fiberboard, blockboard and particleboard. It can be an automatic production line that can transport edge banding boards, belts, up and down milling and polishing at one time. The main performance of its products reaches or exceeds the domestic similar products.
Advanced level and low price, especially suitable for manufacturers of panel furniture.
Edge band thickness: 0.4 ～ 3mm
Edge banding height: 10 ～ 60mm
Workpiece thickness: 12 ～ 55mm
Minimum width: 70mm
Minimum length: 160mm
Conveying speed: 9.5m / min
Vertical milling motor: 0.75kw18000rpm 300HZ
Up and down polishing motor: 0.18kwX21400rpm
Rubber box heater: 1.6kw
Conveying motor: 1.5 kw
Air pressure: 0.6Mpa
Total power: 4.21 kw
Weight: 800KG Product details